Figure 72: Removing A Fan Module From A 1 U Qfx5100 Device - Juniper QFX5100 Hardware Manual

Copyright © 2016, Juniper Networks, Inc.
Before you remove a fan module from a QFX5100 device, ensure that you have taken
the necessary precautions to prevent electrostatic discharge (ESD) damage (see
"Prevention of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to remove a fan module
from a QFX5100 device:
ESD grounding strap
Antistatic bag or an antistatic mat
To remove a fan module from a QFX5100 device (see
Figure 73 on page 200):
Place the antistatic bag or the antistatic mat on a flat, stable surface.
1.
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
2.
point on the chassis.
Using a Phillips screwdriver, loosen the locking screw (3 or 4 turns).
3.
Grasp the handle on the fan module and squeeze the outside of the handle to release
4.
the module.
WARNING: To avoid injury, do not touch the fan with your hands or any
tools as you slide the fan module out of the chassis—the fan might still
be running.
Pull firmly to slide the fan module halfway out of the chassis.
5.
When the fan stop spinning, slide the fan module completely out of the chassis.
6.
Place the fan module in the antistatic bag or on the antistatic mat placed on a flat,
7.
stable surface.

Figure 72: Removing a Fan Module from a 1 U QFX5100 Device

Chapter 16: Replacing Cooling System Component
263).
Figure 72 on page 199 and
199