Figure 10: Leds On The Uplink Ports And Port Status Mode Leds In An Ex2200 Switch Except The Ex2200-C Switch Model; Figure 11: Port Status Mode Leds Of The Dual-Purpose Uplink Ports Of An Ex2200-C; Table 5: Link/Activity Led On The Network Ports And Uplink Ports In Ex2200 - Juniper EX2200 Series Hardware Manual

Table 5: Link/Activity LED on the Network Ports and Uplink Ports in EX2200 Switches
LED Color
Link/Activity Green
Copyright © 2011, Juniper Networks, Inc.
Figure 10: LEDs on the Uplink Ports and Port Status Mode LEDs in an
EX2200 Switch Except the EX2200-C Switch Model
Link/Activity Status Port status
LED LED mode LEDs
SPD
DX
0 1 2 3
EN
POE
Port 0 Port 1 Port 2 Port 3
Figure 11: Port status mode LEDs of the Dual-purpose uplink Ports of an
EX2200-C Switch
Table 5 on page 15 describes the Link/Activity LED.
State and Description
Blinking—The port and the link are active, and there is link activity.
On steadily—The port and the link are active, but there is no link activity.
Off—The port is not active.
In Figure 9 on page 14, Figure 10 on page
indicate the status of one of the four port parameters—speed, duplex mode, administrative
status, and Power over Ethernet (PoE) status. Use the mode button below the POE LED
on the far right side of the front panel to toggle the Status LED to show the different port
parameters. You can tell which port parameter is indicated by the Status LED by seeing
which port status mode LED (SPD, DX, EN, and POE) is lit. (See
Table 6 on page 16 describes the Status LED.
Mode
button
Port status mode LEDs
Dual-purpose
uplink ports
15, and Figure 11 on page 15
Chapter 2: Component Descriptions
show the LEDs that
Figure 10 on page 15).
15