Juniper QFX5100 Hardware Manual page 210

QFX5100 Switch Hardware Guide
Related
Documentation
190
(Optional) Configure the name of the switch. If the name includes spaces, enclose
6.
the name in quotation marks (" ").
[edit]
root@# set system host-name host-name
Configure the default gateway.
7.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the switch management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported.
NOTE: The management ports,
FRU end of the QFX5100 switch.
(Optional) Configure the static routes to remote prefixes with access to the
9.
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
Enable telnet service.
10.
[edit]
root@# set system services SSH
NOTE: When Telnet is enabled, you cannot log in to a QFX5100 switch
through Telnet using root credentials. Root login is allowed only for SSH
access.
Enable SSH service for root login.
11.
[edit]
root@# set system services SSH
Commit the configuration to activate it on the switch.
12.
[edit]
root@# commit
Installing and Connecting a QFX5100 Device on page 159
em0 ( C0 ) and em1 ( C1 ) are found on the
Copyright © 2016, Juniper Networks, Inc.