Juniper QFX5100 Hardware Manual page 161

Table 49: Third-Party QSFP+ DAC Cable Support (continued)
Platform
QFX3500 device as a standalone switch
QFX5100 device as a standalone switch
Copyright © 2016, Juniper Networks, Inc.
NOTE: This topic does not describe which devices support these transceivers.
For information about which transceivers are supported on QFX Series devices,
see the
Hardware Compatibility Tool
Interface Support for the QFX3600 Device
Interface Support for the QFX3500 Device
Interface Support for the QFX5100 Device on page 86
Interface Support for the QFX3008-I Interconnect Device
The cables are hot-removable and hot-insertable. A cable consists of a cable assembly
that connects directly into two QSFP+ modules, one at each end of the cable. The cables
use integrated duplex serial data links for bidirectional communication and are designed
for data rates up to 40 Gbps.
Passive DAC cables have no signal amplification built into the cable assembly.
The Hardware Compatibility Tool
cable specifications for QSFP+.
Active DAC cables have signal amplification and equalization built into the cable assembly.
The
Hardware Compatibility Tool
specifications.
Chapter 8: Port and Interface Specifications
Third-Party DAC Cable Support Added
Junos OS Release 12.2X50-D10
Junos OS Release 12.2X51-D10
or the following topics:
and Table 50 on page 142
and Table 51 on page 144 describe the active DAC cable
describe the passive DAC
141