Removing A Fan Module From An Ocx1100 Switch; Figure 34: Installing A Fan Module In An Ocx1100-48Sx Switch - Juniper OCX1100 Hardware Manual

OCX1100 Switch Hardware Guide

Documentation

Removing a Fan Module from an OCX1100 Switch

106

Remove the fan module from its bag.

Hold the handle of the fan module with one hand and support the weight of the module

with the other hand. Place the fan module in the fan module slot on the rear panel of

the switch and slide it in until it is fully seated and the clip clicks into place. See

Figure 34 on page 106

Figure 34: Installing a Fan Module in an OCX1100–48SX Switch

NOTE:

If you have a Juniper J-Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/support/tools/updateinstallbase/

to do so can result in significant delays if you need replacement parts. This

note does not apply if you replace existing components with the same type

of component.

Removing a Fan Module from an OCX1100 Switch on page 106

Cooling System and Airflow in an OCX1100 Switches on page 17

Field-Replaceable Units in OCX1100 Switches on page 12

OCX1100 Switches Hardware Overview on page 3

The fan module in OCX1100 switches is a hot-removable and hot-insertable

field-replaceable unit (FRU) installed in the rear panel of the switch: You can remove

and replace it without powering off the switch or disrupting switch functions.

Ensure that you have the following parts and tools available:

Phillips (+) screwdriver

An antistatic bag or an antistatic mat

A replacement fan module

. Failure

Table of Contents