Figure 175: Disconnecting Power Cables From The Dc Power Supply - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
358

Figure 175: Disconnecting Power Cables from the DC Power Supply

Remove the cable lugs from the terminal studs.
6.
Loosen the captive screw or screws on the cable restraint on the right edge of the
7.
power supply faceplate.
Carefully move the power cables out of the way.
8.
Loosen the captive screws on the lower corners of the power supply faceplate
9.
completely.
Twist the ejector handles on the upper corners of the faceplate counterclockwise to
10.
unseat the power supply.
Grasp the handle on the power supply faceplate and pull firmly. Slide it halfway out
11.
of the chassis (see Figure 177 on page 359).
Copyright © 2017, Juniper Networks, Inc.