16
HYDRAULIC ATTACHMENT SYSTEM
3. Remove retaining pin (1) from the base end of the hydraulic cylinder (Figure 16-40, Page 16-28).
4. Remove pivot pin (2) (Figure 16-41, Page 16-28) from the base end of the hydraulic cylinder and
remove cylinder.
Figure 16-40 Remove Retaining Pin
Auxiliary Cylinder Installation
1. Reverse the removal procedure to install the auxiliary hydraulic cylinder in the attachment.
2. Install the retaining pin (1) as shown (Figure 16-39, Page 16-27). See following NOTE.
NOTE: If installed wrong, this retaining pin will restrict attachment travel.
Page 16-28
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
2
1
Figure 16-41 Remove Pivot Pin
Cylinders