Club Car 2007 Carryall 295 Maintenance And Service Manual page 484

14
DRIVETRAIN COMPONENTS
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL. Chock the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-2.
3. Gasoline vehicles: Disconnect the spark plug wires. See WARNING "To avoid unintentionally start-
ing..." in General Warning, Section 1, Page 1-2.
4. Raise the hood.
5. Disconnect the cable ball socket from the shifter handle ball stud (Figure 14-22, Page 14-16).
6. Loosen the flanged nuts from the cable at the shifter handle bracket (Figure 14-23, Page 14-16).
Figure 14-22 Forward/Reverse Shifter Cable Ball
Socket At Shifter Handle Ball Stud
NOTE: Note the positions of the flanged nuts on the cable. The nut farthest from the handle should be at
the farthest end of the threaded portion of the cable.
7. Remove the passenger seat.
8. Note the positions of the wire ties that secure the cable between the dash and the transmission and then
remove the wire ties.
9. Disconnect the cable ball socket from the ball stud on the transmission shifter arm (Figure 14-24,
Page 14-17).
10. Loosen the flanged nuts from the cable bracket that is below and forward of the transmission shifter arm.
See following NOTE.
NOTE: Note the positions of the flanged nuts on the cable. This hardware will be used to adjust the handle
position during installation.
Secure a heavy nylon cord to the transmission end of the cable. Pull the cord and cable at the dash
frame from the transmission and allow the cord to travel under the body.
11. Remove the shifter cable.
Page 14-16 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Figure 14-23 Forward/Reverse Shifter Cable Flanged
Nuts At Shifter Handle Bracket
Transmission