Club Car 2007 Carryall 295 Maintenance And Service Manual page 504

16
HYDRAULIC ATTACHMENT SYSTEM
6. Remove the two retaining rings (4 and 7) and pins (3 and 6) that secure the two cylinders (1 and 5) to
the mount (2) (Figure 16-14, Page 16-6).
Figure 16-13 Align the Attachment Arm Holes
ACTIVATE
TOGETHER
FOR FLOAT
Figure 16-15 Joystick
7. Swing the attachment interface cylinder down.
8. Turn the key to the ON position but DO NOT start the engine.
9. Move the joystick (1) forward to extend the attachment arm cylinder (Figure 16-15, Page 16-6).
10. Move the joystick (1) to the right to extend the attachment interface cylinder.
11. Turn the key to the OFF position.
NOTE: When aligning the cylinders to the attachment arm and interface during installation, the cylinders
may need to be retracted slightly to relieve the hydraulic pressure. Do not have hands in the area
of the cylinders when extending or retracting the cylinders.
12. Raise the attachment arm (1) and align it with the cylinder (2). Install the pin (3) and retaining ring (4)
(Figure 16-16, Page 16-6).
Page 16-6 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
FLOAT
1
AUX HYD
Figure 16-14 Remove Retainer Pins from Both Cylin-
ders
Figure 16-16 Raise Attachment Arm, Install Pin, and
Retainer Ring
Attachment Interface