Club Car 2007 Carryall 295 Maintenance And Service Manual page 340

12C
ELECTRICAL COMPONENTS: DIESEL VEHICLES
Figure 12c-8 Reverse Warning Buzzer Limit Switch
Reverse Warning Buzzer Limit Switch Installation
1. Install the reverse warning buzzer limit switch in the reverse order of removal.
2. Place the Forward/Reverse handle in the REVERSE position.
3. Tighten the limit switch mounting screws so that they are snug, but the limit switch can still be rotated in
the adjustment slot (Figure 12c-8, Page 12c-12).
4. Rotate the limit switch so that the lobe on the Forward/Reverse handle activates the limit switch as shown
(Figure 12c-9, Page 12c-12).
5. Hold the limit switch in position and tighten the mounting screws and nuts to 4 in-lb (0.5 N·m). See fol-
lowing CAUTION.
CAUT ION
• Do not overtighten the retaining nuts. If the nuts are overtightened, the limit switch could
become damaged.
6. Place the Forward/Reverse handle in NEUTRAL and then back to REVERSE to ensure that the limit
switch lever is being properly activated.
7. Connect the 18-gauge red and 18-gauge red/white wires to the limit switch.
8. Lower and secure the hood.
9. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
10. Turn the key switch to the ON position. With the Forward/Reverse handle in REVERSE, the buzzer
should sound.
Page 12c-12 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Adjustment Slot
Reverse Warning Buzzer Limit Switch (If Equipped)
Figure 12c-9 Reverse Warning Buzzer Limit Switch
(Properly Adjusted)