Club Car 2007 Carryall 295 Maintenance And Service Manual page 502

16
HYDRAULIC ATTACHMENT SYSTEM
1. Lower the attachment arm to the ground and tilt the attachment interface forward (Figure 16-5,
Page 16-3).
2. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your
seat belt, and exit the vehicle.
3. Remove the retaining ring (1) and pin (2) from the attachment interface cylinder rod end, and keep the
retaining ring and pin for later use in this procedure (Figure 16-6, Page 16-3).
4. Remove the retaining ring (1) and the pin (2) from the attachment arm cylinder rod end (Figure 16-7,
Page 16-4).
Figure 16-7 Remove Attachment Cylinder Retaining
5. Turn the start key to the ON position but DO NOT start the engine.
6. Retract the attachment arm cylinder fully by moving the joystick (1) back (Figure 16-8, Page 16-4).
7. Retract the attachment interface cylinder fully by moving the joystick (1) to the left.
8. Turn the start key to the OFF position.
9. Rotate the attachment arm cylinder (1) vertically against the mount (2) (Figure 16-9, Page 16-5).
10. Install the existing pin (3) and retaining ring to secure the cylinder to the mount.
11. Rotate the attachment interface cylinder (5) upward against the vehicle and snap it into place (8).
12. Install the existing pin (6) and retaining ring (7) in the locking hole on the mounting plate.
13. Remove the two retaining rings (1) and pins (2) from the attachment arms and mounting plate
(Figure 16-10, Page 16-5).
14. Lower the attachment arm to the ground.
15. To store, install pins (1) into the attachment arm holes (both sides) and secure with the retaining pins (2)
(Figure 16-11, Page 16-5).
Page 16-4 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Pin
Attachment Interface
FLOAT
ACTIVATE
TOGETHER
FOR FLOAT
1
AUX HYD
Figure 16-8 Joystick