Club Car 2007 Carryall 295 Maintenance And Service Manual page 460

13C
DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES
Page 13c-31). Do not use a brush or steel wool. These abrasives will damage the surface of
the shaft.
• Do not use solvents. Solvents will damage the lubricating characteristics of the bushings.
2. Inspect the belt contact surfaces of the clutch sheaves for wear. If any area of a sheave contact surface
has wear of 0.060 inch (1.52 mm) or more, the clutch should be replaced.
Drive Clutch Disassembly
The following service tools are required to disassemble the drive clutch and are available from a service parts
representative:
• Fixed sheave tool (CCI P/N 102601501)
• Spider tool (CCI P/N 102607501)
12
Figure 13c-31 Drive Clutch Service Tools
1. Use a 7/16-inch socket to remove the four bolts (1) and washers (2) that secure the plate (3) to the clutch
cover (4) (Figure 13c-32, Page 13c-31).
2. Remove the cover (4) and spring (5) from the clutch spider (6).
3. Inspect the torque rollers (7), weights (11) and rollers (10). Replace if necessary.
4. Secure the Fixed sheave tool (CCI P/N 102601501) into a vice, or mount the tool to a flat work surface
(Figure 13c-31, Page 13c-30).
5. Place the fixed sheave of the drive clutch onto the service tool so that the drive clutch is stationary.
Page 13c-30 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
SPIDER REMOVAL
TOOL (CCI P/N 102607501)
DRIVE CLUTCH
FIXED SHEAVE TOOL
(CCI P/N 102601501)
Clutches