Club Car 2007 Carryall 295 Maintenance And Service Manual page 210

11B
TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES
6. Turn the key switch ON. Place the red (+) probe of the multimeter on the (B) terminal and the black (–)
probe on the (L) terminal of the key switch. The reading should indicate continuity. If the reading does not
indicate continuity, replace the key switch (Figure 11b-8, Page 11b-14). See Key Switch Removal,
Section 12b, Page 12b-6.
WAVETEK
V OFF
1000
200
20
2
200
m
2000
k
200k
20k
2k
!
V COM
MAX
1000 ---
750V
Reading with key switch
in the ON position
Figure 11b-8 Key Switch Test – Accessory Terminal
7. With the key switch still in the ON position, place the red (+) probe of the multimeter on the (B) terminal
and the black (–) probe on the (S) terminal of the key switch. The reading should indicate no continuity.
If the reading indicates continuity, replace the key switch. See Key Switch Removal, Section 12b,
Page 12b-6. If the reading does not indicate continuity, leave the probes connected and proceed to step
8.
8. Turn and hold the key switch in the START position. The reading should indicate continuity. If the reading
does not indicate continuity, replace the key switch (Figure 11b-9, Page 11b-14). Place the red (+) probe
of the multimeter on the (B) terminal and the black (–) probe on the (L) terminal of the key switch, the
reading should indicate continuity. If either reading does not indicate continuity, replace the key switch.
See Key Switch Removal, Section 12b, Page 12b-6.
TEST PROCEDURE 5 – KEY SWITCH (ACCESSORY TERMINAL)
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
3. Ensure that the key switch connector is connected correctly and is tight. If it is not, repair or replace as
necessary.
4. Remove the key switch. See Key Switch Removal, Section 12b, Page 12b-6.
5. Turn the key switch to the ON position. With the multimeter set to 200 ohms, place the red (+) probe on
the (B) terminal and the black (–) probe on the (L) terminal of the key switch (Figure 11b-8,
Page 11b-14). The reading should indicate continuity. If the reading does not indicate continuity, replace
the key switch. See Key Switch Removal, Section 12b, Page 12b-6.
Page 11b-14 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
M B
L
G
5XL
V
500
200 S
200
2m
20
m
200
m
200
A
!
200nA
FUSED
M
L
WAVETEK 5XL
V
V OFF
1000 500
200 200 S
20 200
2 2m
200
20
m
m
200
2000
k m
200k
20k 200
2k A
! ! 200nA
V COM
MAX
1000 ---
FUSED
750V
Reading with key switch
in the START position
Figure 11b-9 Key Switch Test – Starter Circuit
Test Procedures
B
G