Club Car 2007 Carryall 295 Maintenance And Service Manual page 191

TROUBLESHOOTING AND ELECTRICAL SYSTEM: KAWASAKI POWERED GASOLINE VEHICLES
5. If the hour meter still does not function after the low oil warning light, oil pressure switch, and all of the
appropriate wires have been checked for continuity, replace the fuel gauge/hour meter.
TEST PROCEDURE 27 – LIGHT SWITCH
See General Warning, Section 1, Page 1-1.
NOTE: The headlight circuit is protected by the 20-amp fuse. Check the fuse before this procedure is per-
formed. See Test Procedure 2 – Fuse on page 11a-12.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Remove the light switch from the instrument panel. See Light Switch Removal, Section 12a,
Page 12a-10.
3. Use a multimeter set to 20 volts DC and place alligator clips on the multimeter probes. Connect the red
(+) probe to the light switch terminal where the blue wire (w03) is connected (Figure 11a-35,
Page 11a-37).
WAVETEK 5XL
V
V OFF
1000 500
200 200
20
200
2 2m
200
20
m
m
200
2000
k m
200k
20k 200
2k A
! ! 200nA
V COM
MAX
1000 ---
FUSED
750V
Figure 11a-35 Light Switch Test
4. Connect the black (–) probe of the multimeter to the negative (–) post of the battery.
5. With the light switch in the OFF position, the reading should indicate 0 volts. With the light in the ON posi-
tion, the reading should indicate between 11 and 12.5 volts. If the there is no voltage reading, check the
continuity of the 10-gauge red wire (w126) from the fuse block to the starter solenoid. Check the conti-
nuity of the 14-gauge yellow wire (w07) and the 14-gauge blue wire (w113) from the light switch to the
fuse block. Check the fuse. See Test Procedure 2 – Fuse on page 11a-12. If the wires and fuse show
continuity and the readings are still incorrect, replace the switch. See Light Switch Removal,
Section 12a, Page 12a-10.
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
11A
Test Procedures
Page 11a-37