Briggs & Stratton Vanguard 05000 Manual page 93

3. Slide carburetor from its mounting studs
and disconnect governor link ([A] Fig. 7)
and anti-backlash spring ([B] Fig. 7) when
carburetor is free.
4. Remove governor link and anti-backlash
spring from governor lever ([C] Fig. 7) and
5
set aside.
5. Remove the carb spacer from the
carburetor mounting studs. SEE
SECTION 13- FINAL ENGINE
ASSEMB LY.
92
Fig. 6
Fig. 7
Fig. 8
Inspect Fuel System. SEE SECTION 5- FUEL
SYSTEM CLEANING AND INSPECTION.
Installation
For torque values: SEE SECTION 14- ENGINE
SPECIFICATIONS.
1. Place gasket, carb spacer and gasket on
mounting studs.
2. Connect governor/choke linkages on
carburetor and position carburetor on
mounting studs.
3. Mount governor control bracket/s (as
required) and connect links and springs.
4. Position shut-off valve and hose into index
hole on blower housing.
5. Install spacer and screw, and torque to
values listed.
6. Connect hose with clamp to carburetor
fitting.
7. Install new hose and clamp on tank outlet
fitting.
8. Connect other end of hose and clamp to
shut-off valve fitting.
9. Route tank hose through retainer on
crankcase cover, then position tank on
engine.
10. Start all screws and nu ts.
NOTE (115400)
: Do not pinch governor link
spring behind head of screw. The ground wire
terminal must be installed under screw on right
side of tank.