Briggs & Stratton Vanguard 05000 Manual page 187

Disassemble Oil Gard® System (161400)
1. Disconne ct wire (A) from float assembly
terminal and remove mounting screws
([B] Fig. 28).
f61p28
2. Remove float assembly ([A] Fig. 29) from
cylinder.
9
f62p28
To service warning light,
1. Disconnect wire connector and remove
light from control panel.
2. Remove air cleaner to gain access to light
(if so equipped).
186
Fig. 28
Fig. 29
Inspect Oil Gard® System (16140 0)
1. Inspect float assembly for cracks in
housing and float.
2. Check Oil Gard® switch operation by
connecting a continuity tester to the wire
terminal and ground clip.
3. In the normal upright position, the tester
should read continuity.
4. Turn the float assembly upside down.
5. The tester should read no continuity.
Assemble Oil Gard® System (161400)
Refer to Fig. 29
1. Install serviceable light assembly in
control panel.
2. Install new gasket ([A] Fig. 29 ) with
sealant bead toward cylinder and float
assembly.
3. Apply sealant to screw threads.
4. Install mounting screws.
5. Torque to listed value. See SECTION 14-
ENGINE SPECIFICATION.
6. Install wire terminal.