Briggs & Stratton Vanguard 05000 Manual page 114

Remove or install jets ([A] Fig. 79) with
carburetor jet screwdriver
Fig. 79
Note the position of the throttle plate.
12. Remove throttle plate screws ([A] Fig.
81) and remove plate (B).
13. Slide the throttle sha ft (C) out of the
carburetor body.
14. Remove the throttle shaft seal (D) and
washer (E).
(#19280)
.
15. Remove and inspect the bushing ([F] Fig.
80). Replace if worn or damaged.
Fig. 80
To clean carburetor:
SEE SECTION 5- FUEL SYSTEMS AND
CARBURETION.
Inspect the idle mixture screw. Replace the
screw if the point is bent or there is a groove in
the tip of the needle.
Assembly
Use new seals and gaskets when assembling
carburetor.
1. Install throttle shaft bushing (A) to
carburetor body with grooved side out,
Fig. 81.
2. Place washer (B) and throttle shaft seal
(C) on the throttle shaft ([D] Fig. 81).
3. Install the throttle shaft to the carburetor
body.
4. Rotate throttle shaft until the flat on the
shaft is facing out.
5
113