Disassemble Rewind Starter With Metal Pawls (104700) - Briggs & Stratton Vanguard 05000 Manual

4. Install paw ls (A) and pawl springs ([B] Fig.
19) in pully.
5. Install retainer spring (A), retainer (B),
washer (C) and retainer screw ([D] Fig.
19).
6. Rotate pully ([A] Fig. 20) clockwise un til
8
inner spring is tight.
7. Lock pulley with screwdriver in fins to
prevent it from unwinding in housing.
168
Fig. 18
Fig. 19
Fig. 20
8. Insert rope through housing and hole in
pulley.
9. Secure rope to pulley with overhand knot.
10. Remove pu lley lock and allow spring to
slowly retract rope into rewind starter
assembly.
11. Install handle. See SECTION 8- Fig. 3.
Disassemble Rewind Starter With
Metal Pawls (104700)
WARNING
Prevent Eye Injury. Wear eye protection
when working on rewind starter pulleys and
springs.
1. Pull starter rope out as far as it will go.
2. Lock pulley to prevent it from retracting in
starter housing.
3. Extract rope at pulley and cut off knot.
4. Remove rope and handle from rewind
starter.
5. Unlock pulley and slowly release spring
tension.
6. Inspect rope for frayed and broken
strands. Replace if worn.
If reusing old rope:
• Burn pulley end of rope to prevent
swelling and unraveling.
7. Remove retainer screw (A) and retainer
([B] Fig. 21).
Fig. 21
8. Lift out starter pawls (A) and pawl spri ngs
([B]).