Oil Pump & Screen Removal/Installation (28Q700) - Briggs & Stratton Vanguard 05000 Manual

Oil Screen Removal/Installation (104700)
The oil pump screen is located inside the sump.
Remove sump from cylinder to clean or replace
the screen.
1. Remove two screen retaining screws ([A]
Fig. 12). Clean or replace as needed.
2. Install screen and torque screws to
listed value. See SECTION 14- ENGINE
SPECIFICATIONS.
Oil Screen Removal/Installation (260700,
261700)
The oil pump screen is located inside the sump.
Remove sump from cylinder to clean or replace
the screen.
1. Drive out screen, Fig. 13Do not reuse.
9
2. Install oil pump screen with hole (A) facing
away from governor shaft bearing ([B]
182
Fig. 12
Fig. 13
Fig. 14).Press screen into position as
shown.
Fig. 14
Oil Pump & Screen Removal/
Installation (28Q700)
Screen Removal/Installation (28Q700)
Three types of oil pump screens were used on
these engines. Oil pump screens ([A]
) were mounted inside the sump
code 94110700
and held with one screw ([B] Fig. 15).
Fig. 15
Remove, clean and/or replace as required.
Torque screw to listed value.
The intermediate screen ([C]
) could be removed from the outside of
94110600
the sump with the oil pump, Fig. 16.
Fig. 16
Before date
After date code