Models 085400, 086400, 115400, 117400, 118400, 13840 0, 185400, 235400, 245400 - Briggs & Stratton Vanguard 05000 Manual

14. Refer to Fig. 12 and install components
as shown.
15. Loosely Install the spark plug and route
the ignition lead as shown in Fig. 13.
13
234
Fig. 12
Fig. 13
MODELS 085400, 086400, 115400,
117400, 1 18400, 138400, 1 85400,
235400, 245400
NOTE
: The 185400 was used as a general
representation of the following models; 085400,
086400, 115400, 117400, 118400, 138400,
235400, 245400. Those engines that have gear
reduction systems are covered in section 11.
With minor variations, the 185400 is a good
outline for the procedures required to assemble
the above mentioned engines.
1. Make sure the wiring harness is routed
and secured as shown in ([A] Fig. 14).
Fig. 14
2. Mount ignition coil ([B] Fig. 14) and
connect ground wire.
3. Mount flyw heel ([A] Fig. 15), making sure
the new woodruff key is in place.
4. Install starter cup ([B] Fig. 15) and torque
flywheel nut to listed value. See
SECTION 14- ENGINE
SPECIFICATIONS.
Fig. 15