Briggs & Stratton Vanguard 05000 Manual page 244

4. Install flywheel with fan, fan retainer and
flywheel nut. Torque nut ([A] Fig. 50) as
shown to values listed in section 14.
Fig. 50
5. Install ignition coil and set air gap.
6. With coil installed and ground wire
connected, route wire through small
clamp ([A] Fig. 51) to grounding terminal
on equipment.
Fig. 51
7. Install governor link with spring (A) and
connect choke arm ([B] Fig. 52) as
shown.
Fig. 52
8. Install air cleaner base to carburetor and
torque mounting nuts ([A] Fig. 53) to
listed values. See SECTION 14- ENGINE
SPECIFICATIONS.
Fig. 53
13
243