Briggs & Stratton Vanguard 05000 Manual page 119

Disasse mble
1. Remove fuel bowl mounting screw (C) and
washer (B). Remove the fuel bowl ([A]
Fig. 95).
2. Remove float bowl gasket ([A] Fig. 96).
5
3. Remove float hinge pin (A), float ([B] Fig.
97), and inlet needle.
Float hinge pin is a drive fit and one end of the
pin has two flats.
4. Tap the end opposite the flats with a
center punch ([C] Fig. 97) until it is loose.
118
Fig. 95
Fig. 96
Fig. 97
5. Remove the main jet (A) from the fuel
pick-up tube.
6. Remove the emulsion tube ([B] Fig. 98)
with a carburetor jet screwdriver.
Fig. 98
7. Remove the pilot jet (A) with Screwdri ver
19062
, Fig. 99.
#