Briggs & Stratton Vanguard 05000 Manual page 194

5. Insert puller screw (B) w ith driver (C)
through ball bearing and thread into
support (D).
Fig. 10
6. Tighten until bearing comes free of cover.
Installation: PTO-Side Ball Bearing
Ball Bearing Installation Tools: (Refer to Fig. 11)
• Washer
([A] #225136)
• Puller Screw
([B] #19318)
• Driver
([C] #19320)
• Pilot Nut
([D] #19395)
1. Lubricate outside of ball bearing.
2. Inse rt puller screw (B) through washer (A)
and through small end of driver (C).
3. Place ball bearing on driver (C).
4. Insert large end of pilot nut (D) into oil seal
boss of cylinder cover.
5. Thread puller screw (B), washer (A),
driver (C) and ball bearing into pilot nut
(D).
Fig. 11
6. Tighten until ball bearing is seated.
Removal: PTO-Side Ball Bearing (With 6:1
Gear Reduction)
Bearing Removal Tools: (Refer to Fig. 12).
• Puller Nut
([A] #19139)
• Puller Stud
([B] #19398)
• Support
([C] #19454)
• Washer
([D] #225136)
• Nut
([E] #94814)
1. Remove governor gear.
2. Assemble puller nut (A) to puller stud (B)
and insert through ball bearing.
3. Place support (C) over ball bearing.
4. Assemble washer (D) and nut (E) to puller
stud (B) and thread nut down to the end of
the threads on sup port (C).
• Hold 3/8" hex end of stud with wrench
while tightening nut (E). Tighten until ball
bearing comes free of cover.
Fig. 12
Installation: PTO-Side Ball Bearing (With 6:1
Gear Reduction) (Fig. 13)
1. Lubricate outside of ball bearing.
10
193