2
5
8
6
3
Fig. 30
1
4
Fig. 31
For final torque values:
See SECTION 14- ENGINE SPECIFICATIONS.
NOTE: (260700, 261700)
used on cylinder head screws outside the valve
cover. Sealing washers are used on cylinder
head screws inside the valve cover.
NOTE: (161400)
The top two cylinder head
bolts without washers are inserted through
cylinder baffle, then cylinder head.
4
1
7
3
2
Plain w ashers are
INSTALL ROCKER ARMS
Install Push Rods & Rocker Arms
(104700, 161400, 260700, 261700,
28Q700)
1. Install push rods (A) through push rod
guide. Make sure push rods are seated in
valve tappets ([B] Fig. 32).
Fig. 32
2. Remove all lubri cant from end of valve
stems.
3. Place valve caps ([C] Fig. 33), (when
used) on end of valve stems.
4. Place rocker arms on studs. Install rocker
arm nuts (D) and screw while holding
rocker arm against valve cap ( [C] Fig. 33).
• Tighten rocker arm until rocker ball is finger
tight.
5. Rotate crankshaft at least two revolutions
to be sure push rods operate rocker arms.
Fig. 33
7
157