Rewind Starters; Remove Rewind Starter Housings (Typical) - Briggs & Stratton Vanguard 05000 Manual

REWIND STARTERS

Remove Rewind Starter Housings
(Typical)
1. Remove four screws (A) holding rewind
starter housing ([B] Fig. 1) and remove.
2. If riveted, drill through rivets. Clean all
debris.
Fig. 1
For starters that are spot welded to blower
housing:
3. Drill out spot welds (A) using a
drill bit ([ B] Fig. 2). Drill only deep
mm)
enough to loosen spot welds.
Fig. 2
4. Reinstall using original screws or use nuts
and bolts ([C] Fig. 2) as listed in the
Illustrated Parts List (IPL).
Install Rope And Handle Assembly
Handles With Inserts
NOTE
handle.
1. To determine proper length of starter rope,
2. Insert rope (A) through starter handle (B)
3. Tie knot on end of rope, leaving
CAUTION:
so it will not pull through pulley, hole in handle
and/or insert.
3/16 i n. (4.8
: Some units do not use an insert in the
see SECTION 14- ENGINE
SPECIFICATIONS. Cut as necessary.
and starter handle insert (C).
approximately 1/2 in. (13 mm) ([D] Fig. 3)
of rope left. Pull knot into handle insert
and pull insert into starter handle.
Knot must be an overhand knot (E)
Fig. 3
8
163