Inspect Rewind Starter With Metal Pawls (104700); Assemble Rewind Starter With Metal Pawls (104700) - Briggs & Stratton Vanguard 05000 Manual

9. Remove brake spring (C).
10. Rotate pulley and spring assembly ([D]
Fig. 22) until pulley feels free.
11. Lift out pulley and spring assembly.
NOTE
: Pulley and spring with retainer are
serviced as an assembly. Do not remove spring
retainer fr om pulley.
Fig. 22
Inspect Rewind Starter With Metal
Pawls (104700)
1. Insp ect starter pulley (A) for cracks, rough
edges, wear, burrs in pulley groove, or a
loose spring retainer ([B] Fig. 23).
Fig. 23
2. Inspect starter housing (A) for wear or
burrs at starter housing eyelet (B), center
pivot post (C), and at inner spring retainer
([D] Fig. 24). Replace damaged or worn
components.
Fig. 24
Assemble Rewind Starter With Metal
Pawls (104700)
1. Note the location of the free end of the
spring in the pulley assembly and of the
inner spring retainer ([A] Fig. 25) in the
starter housing.
Fig. 25
2. Line up the free end of spring with the
spring retainer (A) in the housing (Fi g.
25). Assemble the pulley in the housing.
3. Rotate pulley countercl ockwise until
spring engages retainer.
8
169