Briggs & Stratton Vanguard 05000 Manual page 21

1
4. Rotate the governor shaft in direction
noted in previous step, until it stops.
5. While holding governor crank, torque the
governor lever nut (left hand
thread)(Fig.2.)
20
Fig. 23
Fig. 24
Static Governor Adjustment
(161400, 104700, 260700, 261700, 28Q700)
1. Loosen nut holding governor lever ([A]
Fig. 25) to governor crank.
2. Rotate throttle linkage from idle to wide
open throttle. Note the direction of rotation
of the governor arm attached to the
throttle linkage.
3. Place and hold the throttle in high speed
position.
4. While holding the throttle plate, rotate the
governor shaft ([B] Fig. 25) until it stops in
the direction noted in step 2.
5. While holding the governor shaft, torque
the governor lever nut to listed value
SEE SECTION 14- ENGINE SPECIFICATIONS.
Fig. 25
Fig. 26
.