Briggs & Stratton Vanguard 05000 Manual page 101

The float hinge pin ([A] Fig. 30) is a wedge fit.
5. Tap the small end of the pin (B) with a
center punch until it is loo se.
6. Remove pin (A) and remove the float ([C]
5
Fig. 30) and inlet needle assembly.
7. Remove pilot jet (A) with Screwdriver #
19062
.
8. Pry off the idle mixture valve limiter (B), if
used. Remove the idle mixture screw and
spring ([C] Fig. 31).
100
Fig. 29
Fig. 30
Fig. 31
9. Remove screws (A) holding choke pl ate
([B] Fig. 32) and remove.
Fig. 32
10. Lift out choke shaft (A) with upper (B)
and lower ([C] Fig. 33) choke shaft
bushings.