Test Key Switch & Solenoid
(138400, 185400, 235400, 245400)
Required Equipment:
Set meter. See Figure 8.
1. Turn the key switch
2. Check for contin uity at the input side (A) o f
the solenoid and ground ([B] Fig. 57).
Fig. 57
If continuity is present:
• Proceed to step 3.
If not:
• Replace key switch.
3. Check for continu ity at the yellow terminal
(A) of the connector coming from the
switch with the key in the
and ground ([B] Fig.
Fig. 58
.
ON
position
START
58).
If continuity is present:
• Proceed to step 4.
If not:
• Replace key switch.
4. Reconnect the connector from the starter
switch.
5. Test for continuity at the output terminal
(A) of the solenoid with the key in the
position and ground ([B] Fig.
START
Fig. 59
If continuity is present:
• Replace starter.
If not:
• Replace solenoid.
Check Starter Motor
(138400, 185400, 235400, 245400)
Required Equipment:
• Digital Multimeter #
• Tachometer #
19200
• DC Shunt
#19468 ([D] Fig. 57)
• A fully charged 12 volt battery Fig. 60.
1. Set multimeter to 300mv. See Figure 7.
59).
.
19464 (E)
57
2