Ball Bearing Service (115400, 117400, 118400) - Briggs & Stratton Vanguard 05000 Manual

5. Tighten screw until bearing is seated.
Ball Bearing Service
(115400, 117400, 118400)
Removal: Magneto-Side Ball Bearing
Bearing Removal Tools: (Refer to: Fig. 8)
• Washer
([A] #225136)
• Puller Screw
• Driver
([C] #19320)
• Support
([D] #19394)
1. Remove oil seal.
2. Assemble washer (A) to puller screw (B)
and insert through large end of driver (C).
3. Place open side of support (D) against ball
bearin g.
4. Insert screw (B) with driver (C) through
ball bearing and thread into support (D).
5. Tighten until ball bearing comes free of
cylinder.
10
192
Fig. 7
([B] #19318)
Fig. 8
Installation: Magneto-Side Ball Bearing
Bearing Installation Tools: (Refer to Fig. 9)
• Support
([A] #19394)
• Washer
([B] #225136)
• Puller Screw
([C) #19318)
• Pilot
([D] #19396)
1. Lubricate outside of ball bearing.
2. Place ball bearing on support (A).
3. Assemble washer (B) to puller screw (C)
and insert through pilot (D).
4. Insert puller screw (C) with small end of
pilot (D) into cylinder and thread into
support (A).
Fig. 9
5. Tighten screw until ball bearing is seated.
6. Install new oil seal . Use large end of driver
and press seal until flush with
(#19320)
cylinder cover.
Removal: PTO-Side Ball Bearing (Crankshaft
& Camshaft)
Ball Bearing Removal Tools: (Refer to Fig. 10)
• Washer
([A] #225136)
• Puller Screw
([B] #19318)
• Driver
([C] #19320)
• Support
([D] #19454)
1. Remove Governor Gear.
2. Remove oil seal.
3. Assemble washer (A) to puller screw (B)
and insert through large end of driver (C).
4. Place open side of driver (C) against ball
bearin g.