Fig. 71
Disasse mbly
1. Remove the float bowl mounting screw
(C), washer (B) and float bowl ([A] Fig.
72).
Fig. 72
2. Remove float bowl gasket (A).
3. The float hinge pin is a wedge fit. One end
of float hinge pin has two flats ([B] Fig.
73). Tap the opposite end of the pin until
loose.
Fig. 73
4. Remove the pin, float and inlet needle
assembly.
Remove fixed main
5.
fuel pick up tube first, Fig. 74, then
remove the emulsion tube ([A] Fig. 74).
Fig. 74
If emulsion tube does not come out with jet:
Reach into carburetor throat with flat
•
blade screwdriver and gently tap top
of stuck emulsion tube until it comes
out (Fig. 75).
jet from end of
(B)
5
111