4. Install flywheel, woodruff key and position
flywheel on crankshaft (Fig. 4).
5. Position the starter cup (A) on top of the
blower fan (B) by aligning the two drive
flanges with the casting depressions.
Install starter hub (if equipped), washer
(C) and flywheel nut ([D] Fig.5).
6. Place Flywheel Strap Wrench
Fig. 6) around outer rim of flywheel.
13
232
Fig. 4
Fig. 5
([A]
#19433
Fig. 6
7. Torque the flywheel nut to value listed in
SECTION 14- ENGINE
SPECIFICATIONS.
8. Position the Oil Gard® module ([A] Fig. 7)
as shown.
Fig. 7