Disassemble Rewind Starter (28Q700) - Briggs & Stratton Vanguard 05000 Manual

4. Install pawls (A), pawl springs (B), and
brake spring ([C] Fig. 26).
5. Place retainer (A) on brake spring and
partially tighten retainer screw ([B] Fig.
27. Pierced holes on retainer must be
between pawls and stop on pulley.
8
6. Torque retainer screw ([B] Fig. 433) to
listed value.
SPECIFICATIONS.
7. Rotate pulley countercl ockwise until
spring is tight.
8. Lock pulley with screwdriver.
170
Fig. 26
Fig. 27
See SECTION 14- ENGINE
9. Insert rope through housing and hole in
pulley.
10. Secure rope to pulley with overhand
knot. See SECTION 8- FIG. 3.
11. Remove pu lley lock and allow spring to
slowly retract rope into rewind starter
assembly.

Disassemble Rewind Starter (28Q700)

NOTE
: If problems are encountered with the
clutch, replace the entire clutch unit. Remove
starter clutch from crankshaft pilot with tool
.
(#19244)
1. Cut knot at starter pulley and remove
rope.
2. Grasp outer end of rewind spring ([A] Fig.
28) with pliers. Pull out of housing as far
as possible.
3. Turn spring 1/4 turn. Remove from pulley
or bend up one of the tangs with Tang
Bender . Lift out starter pulley to
#19480
disconnect spring.
Fig. 28
4. Clean rewind housing, pulley and rewind
spring in solvent. Wipe clean with cloth.