Briggs & Stratton Vanguard 05000 Manual page 242

6. Install the ignition coil harness to the
ground term inal (A) and route the
harness ([B] Fig. 42) as shown.
Fig. 42
7. Loosely position the back plate and route
the alternator wires as shown in ([A]
Fig.43).
Fig. 43
8. Tighten all back plate mounting screws to
the torque listed. See SECTION 14-
ENGINE SPECIFICATIONS.
9. Install electric starter.
10. Install the flywheel with its woodruff key.
When positioni ng the fan assembly on the
flywheel, make sure the cutout for the
magnet is properly positioned.
11. Install the fan retainer, flywheel nut and
starter cup. Torque to listed values.
Fig. 44
12. Install the ignition coil and set the air gap.
13. Install the exhaust system. See
SECTION 4- EXHAUST SYSTEMS.
Route the spark plug wire as shown in
([A] Fig. 45).
Fig. 45
13
241