Governor Component Inspection; Governor Crank Bushing Replacement - Briggs & Stratton Vanguard 05000 Manual

5. Remove spring clip ([A] Fig. 23).
6. Push governor crank down through
cylinder and out of bearing.
7. Pry out governor crank seal. Do not
damage seal bore. Discard seal.
6
f34p14

Governor Component Inspection

Refer to (Fig. 24).
1. Pry governor gear from shaft, if necessary
2. Inspect the governor gear (A) for wear and
chipped or damaged teeth.
3. Inspect the governor flyweight pivots (B)
for freedom of movement.
4. Ensure that cup (C) is retained throughout
the flyw eight travel.
142
Fig. 22
Fig. 23
5. Inspect bushing for burrs or foreign
materi al.
f35p15
Fig. 24
If discrepancies are found:
• Replace the go vernor gear as a complete
assembly.
If the shaft bushing is damaged or worn:
• Replace bushing.
Governor Crank Bushing
Replacement
1. Remove bushing with a .375 in. (9.5 mm)
rod ([A] Fig. 25) by driving downward into
the cylinder housing.
2. From the outside, use tool
press new bushing into cylinder until it is
flush with the outside surface.
3. Finish ream the bushing using tool
.
(#19333)
and
(#19204)