Briggs & Stratton Vanguard 05000 Manual page 116

Fig. 86
Place emulsion tube
12.
up first, then install fixed main jet
.
Fig. 87)
13. Install the emulsion tube (B) with jet
#19062
screwdriver , (C) and install the
fixed main jet ([A] Fig. 87).
Fig. 87
NOTE:
For main jet and pilot jet identification
and selection, See Identifying Main Jets on page
14. Install spring (A) to groove in fuel needle
valve ([B] Fig. 88).
in fuel pick
(B)
([A]
Fig. 88
15. Slide fuel need le valve assembly (A) on
to tab (B) of float ([C] Fig. 89).
Fig. 89
16. Place float assembly (A) in carburetor,
Fig. 90.
17. Insert the small end of the float hinge pin
(B) by hand until pin is through the float
hinge (C) and both hinge pin posts (D),
Fig. 90.
5
115