Briggs & Stratton Vanguard 05000 Manual page 18

Throttle Control
(161400, 104700, 260700, 261700)
Refer to Figures 16 and 17 that show your
engine.
1. Loosen casing clamp screw (A).
2. Move throttle to
FA ST
3. Move casing in direction of arrow (B) until
casing stops.
4. Tighten casing clamp screw.
Fig. 16
Fig. 17
Choke Control
(050000, 085400, 086400, 115400, 117400,
118400, 138400, 185400, 235400, 245400)
The choke on these models has a separate
manual control.
Ensure that the choke valve is completely open
or closed when the con trol is moved through its
range of motion.
.
Choke-A-Matic®
(104700, 161400, 260700, 261700,
28Q700)
Choke control cables are often provided by the
original equipment manufacturer. Please refer to
the information provided by the OEM when this
general description is not sufficient to adjust the
choke control.
1. Loosen choke con trol casing clamp screw
on engine control panel or governor
control bracket.
2. Move choke control lever or kno b to
.
CHOKE
3. Move choke control casing in the direction
that completely closes the choke valve.
4. Tighten the casing clamp screw.
Choke-A-Matic® Adjustments (161400)
Refer to the figure that shows your engine.
1. Move throttle control to
the choke link should contact the end of
the choke lever slot. To adjust, expand or
contract loop (A) in the choke link.
2. Move equipment control lever to
The choke plate must be closed. Readjust
as required.
Fig. 18
1
. The end of
FAST
.
CHOKE
17