Ball Bearing Service (235400, 245400) - Briggs & Stratton Vanguard 05000 Manual

Installation: Counter-Balance Ball Bearing
Bearing Installation Tool: (Refer to Fig. 19)
• Driver
([A] #19320)
1. Oil outside of ball bearing.
2. Using an arbor press and driver (A), press
ball bearing until it is seated.

Ball Bearing Service (235400, 245400)

Removal: Magneto-Side Ball Bearing
Bearing Removal Tools (Refer to Fig. 20).
• Washer
([A] #225136)
• Puller Screw
• Driver
([C] #19320)
• Support
([D] #19394)
1. Remove oil seal.
10
196
Fig. 19
([B] #19318)
Fig. 20
2. Assemble washer (A) to puller screw (B)
and insert through large end of driver (C).
3. Place open side of support (D) against ball
bearin g.
4. Insert puller screw (B) w ith driver (C)
through ball bearing and thread into
support (D).
5. Tighten until bearing comes free of
cylinder.
Installation: Magneto-Side Ball Bearing
Bearing Installation Tools: (Refer to Fig. 21)
• Washer
([A] #225136)
• Puller Screw
([B] #19318)
• Pilot
([C] #19396)
• Support
([D] #19440)
1. Lubricate outside of bearing.
2. Place ball bearing on support (D).
3. Assemble washer (A) to puller screw (B).
4. Insert small end of pilot (C) into seal boss
in cyl inder.
5. Insert screw (B) through pilot (C) and
thread into support (D).
6. Tighten until ball bearing until seated.
Fig. 21
Removal: PTO-Side Bearing
Bearing removal tools: (Refer to: Fig. 22)
• Washer
([A] #225136)
• Puller Screw
([B] #19318)
• Driver
([C] #19320)
• Support
([D] #19440)
1. Remove governor gear.