Model 104700 - Briggs & Stratton Vanguard 05000 Manual

14. Mount the Oil Gard® module ([A] Fig. 21)
as shown and connect wires to the stop
switch.
15. Install the breather tube (A) and route the
spark plug wire ([B] Fig. 22) as shown.
16. Mount trim cover over the throttle and
choke controls.

MODEL 104700

1. Install electric starter (if equipped ).
2. Position governor lever in position as
shown in ([A] Fig. 23).
13
236
Fig. 21
Fig. 22
Fig. 23
3. Place large carburetor gasket-adapter ([A]
Fig. 24).
Fig. 24
4. With the governor lever in position, loosely
install both control brackets ([A & B]
Fig.25).
Fig. 25
5. Connect governor return spring ([A]
Fig.26).
Fig. 26
6. Position the back plate ([A] Fig. 27) and
loosely start the mounting screws.
7. Mount the alternator (B) and the ignition
coil (C).