Briggs & Stratton Vanguard 05000 Manual page 104

Fig. 41
CAUTION: Emulsion tube ([A] fig. 42) must be
installed before main jet (B) or damage to th e
threads of the emulsion tube will result.
9. Install emulsion tube (A) with screwdriver
#19061
. Install main jet ([B] Fig. 42).
Fig. 42
FOR MAIN JET AND PILOT JET
IDENTIFICATION, SEE IDENTIFYING MAIN
AND PILOT JETS ON PAGE 107.
10. Install pilot jet ([A] Fig. 43).
11. Install idle mixture screw ([B] Fig. 43)
and spring.
12. Turn mixture screw in until it just makes
contact with the seat.
13. Back mixture screw off 1-1/2 turns.
14. Install limiter ([C] Fig. 43) if used.
Fig. 43
15. Install spring (A) to groove in fuel needle
valve ([B] Fig. 44).
Fig. 44
16. Slide fuel need le valve assembly (A) on
tab (B) of float ([C] Fig. 45).
Fig. 45
17. Place float assembly ([A] Fig. 46) in
carburetor.
18. Insert the small end of the float hinge pin
(B) by hand until pin is through the float
5
103