Briggs & Stratton Vanguard 05000 Manual page 121

15. Using carburetor nozzle screwdriver #
19280
, remove main carburetor emulsion
tube ([A] Fig. 104).
5
TO CLEAN CARBURETOR: SEE SECTION 5-
FUEL SYSTEMS AND CARBURETION.
Assembly
1. Assemble retainer ([A] Fig. 105) on choke
shaft (B).
2. Place choke shaft spring (C) on shaft and
hook small hook in notch on choke lever
3. Assemble washer (D), and retainers (E) to
choke shaft.
4. Insert choke shaft assembly into
carburetor body. Engage large end of
return spring (C) on boss.
5. If the carburetor has a spring detent, guide
the detent spring into the slot on the
choke shaft lever.
6. Place choke plate (F) on shaft, single
notch on edge towards fuel inlet. Two half
moon dimples position the plate on the
120
Fig. 103
Fig. 104
shaft. Secure with two screws ([ G] Fig.
105).
Fig. 105
1. Install throttle shaft seal (A) to carburetor
body. Install seal with grooved side out.
2. Place plastic throttle shaft seal (B) o n
throttle shaft ([C] Fig. 106).
3. Install throttle shaft to carburetor body.
Fig. 106
4. Rotate throttle shaft until the flat side of
the shaft is facing out.
5. Lay the throttle plate (A) on the shaft with
the stamped numbers ([B] Fig. 107) to the
left. Install two screws with lock washers.