Briggs & Stratton Vanguard 05000 Manual page 115

5. Lay the throttle plate (A) on the shaft with
the stamped numbers (B) to the left.
Install two screws ([C] Fig. 82).
5
6. Rotate throttle shaft to check for binding.
Correct if required.
7. Install spring (A), washer (B), bushing (C)
and seal (D) to choke shaft ([E] Fig. 83).
8. Insert shaft to carburetor body, Fig. 83.
9. Connect the ends of the spring (A) to the
lever (B) and carburetor body (C). The
114
Fig. 81
Fig. 82
Fig. 83
spring should hold the choke plate open
Fig. 84.
Fig. 84
10. Place choke plate (A) on choke shaft
with stamped nu mber(s) (B) facing
opposite the fuel inlet (C). Attach with
screws ([D] Fig. 85).
Fig. 85
11. Install pilot jet ([A] Fig. 86).