Briggs & Stratton Vanguard 05000 Manual page 127

8. Remove the throttle plate, throttle sha ft
with lever. Remove the foam seal.
5
9. Remove the throttle shaft bushing from
the carburetor body.
10. Rotate the choke shaft ([C] Fig. 125) to
wide open.
11. Pull the choke plate ([D] Fig. 125) out of
the choke shaft slot.
12. Remove the choke shaft, lever, return
spring (if used) and the foam seal.
13. Remove the float bowl.
14. Remove the emulsion tube ([E] Fig. 126)
with Carburetor Jet Screwdriver
126
Fig. 124
Fig. 125
#19280
.
Fig. 126
15. Remove float hinge pin (A), float ([B] Fig.
127), and inlet needle.
Float hinge pin is a drive fit and one end of the
pin has two flats.
16. Tap the end opposite the flats with a
center pun ch ([C] Fig. 127) until it is loose.
Fig. 127
To clean carburetor:
SEE SECTION 5- FUEL SYSTEMS AND
CARBURETION.
Assembly
1. Press the new fuel inlet seat (C) in until it
is flush with the fuel inlet boss ([D] Fig.
128).