Briggs & Stratton Vanguard 05000 Manual page 120

Fig. 99
8. Remove idle mixture screw with spring
([A] Fig. 100).
Fig. 100
9. Unhook the choke shaft spring ([A] Fig.
101).
10. Remove the choke plate screws (B).
Remove the choke plate (C). Remove the
shaft (D), spring (A), washer (E), and
retainers (F) and ([G] Fig. 101).
Fig. 101
11. Remove the air jets located on either
side of the choke plate opening with
carburetor jet screwdriver
12. Note the position of the throttle plate for
reinstallation.
13. Remove the throttle shaft screws ([B]
Fig. 101)Remove the throttle plate.
Low emissio n LMT carburetors with type
numbers that end in A1 or E1 have pressed in
pilot jets that are not removable.
Do not remove the pressed in pilot jets ([A] Fig.
102).
Fig. 102
14. Remove brass pilot jet ([A] Fig. 103) from
carburetor body.
# 19280
.
5
119