Briggs & Stratton Vanguard 05000 Manual page 218

Install Gear Reduction Housing
(115400, 118400)
1. Install new cork gasket on housing, and
place housing against cylinder cover in
original position, Fig. 27.
Fig. 27
2. Install mounting screws (A) and locking
plates ([B] Fig. 27. Torque to listed value.
See SECTION 14- ENGINE
SPECIFICATIONS.
3. Bend one ear of locking plates against flat
on screw heads inside gear housing,
(Inset, Fig. 28).
Fig. 28
4. Install large reduction gear (C) and cover
gasket ([D] Fig. 29).
5. Insert seal protector (E) in seal of cover.
Install cover ([F] Fig. 29) to gear case.
Fig. 29
6. Install cover screws and torque to listed
value.
7. Check end play of PTO shaft. End play
limits:
0.002 - 0.030 in. (0.05 - 0.76 mm)
Filling Reduction Gear Case (115400, 118400)
1. To fill gear case, remove oil level plug ([A]
Fig. 30) and oil fill/vent plug (B).
2. Fill gear case with SAE 30W.
3. Fill gear case just to the point of
overflowing at the lower hole (C).
Fig. 30
4. Install oil level plug in lower hole and
torque to listed value.
5. Install oil fill/vent plug in top hole of the
case and torque to listed value. See
SECTION 14- ENGINE
SPECIFICATIONS.
.
11
217