Briggs & Stratton Vanguard 05000 Manual page 130

Fig. 133
6. Remove the float base gasket ([M] Fig.
134) from the carburetor body.
Fig. 134
7. Press down on the main jet ([N] Fig. 135)
to remove it from the float base tube.
8. Replace the float base if it shows signs of
wear or damage.
Place the main jet into the float base tube. Press
the jet in until it clicks into position. Do not force.
Fig. 135
9. Remove two screws (A) and throttle plate
(B) and pull the throttle shaft ([C] Fig. 136)
from the carburetor body.
Fig. 136
10. Remove the idle mixture screw with
spring (D) and the idle speed screw with
spring ([E] Fig. 137).
Fig. 137
11. Turn the choke plate as shown in
Fig.138.
12. Pull the choke plate (F) from the choke
shaft ([G] Fig. 138).
13. Remove the choke shaft with lever,
return spring and foam washer.
5
129