Briggs & Stratton Vanguard 05000 Manual page 107

3. Push float hinge pin (A) out of th e hinge
posts (B). Remove float (C) and needle
assembly ([D] Fig. 53).
4. The float hinge pin ([A] Fig. 53) is a slip fit.
5
5. Remove the main jet (A) and the emulsion
tube ([B] Fig. 54).
For correct main jet and pilot jet identification,
See Identifying Main Jets on page 107.
Before Date Code 90042933
The emulsion tube can not be removed with the
main jet in the carburetor. Unscrew the main jet
first, then the emulsion tube.
106
Fig. 53
Fig. 54
After Date Code 90042833
Remove the fixed main jet. Remove the main
emulsion tube with Carburetor Jet Screwdriver,
#19062
.
6. Pry off the idle mixture valve limiter (if
used). Remove the idle mixture scr ew and
spring from carburetor body ([A] Fig. 55).
7. Remove pilot jet ([B] Fig. 55) with Jet
#19062
Screwdriver
Fig. 55
8. Remove choke plate screws (A). Remove
choke plate (B),
9. Unhook choke shaft spring ([C] Fig. 56).
10. Remove choke shaft (D) and upper
retainer (E), spring (C), washer (F), seal
(G), and lower retainer ([H] Fig. 56).
Fig. 56
.