Assemble Rewind Starter
(115400, 117400, 118400, 138400,
185400, 260700, 261700)
1. Lay starter housing flat on work bench.
2. Position pulley and coil spring assembly
(A) over center pivot post ([B] Fig. 7) in
starter housing.
Fig. 7
3. Rotate pulley counterclockwise until slight
resistance is felt, indicating that spri ng is
engaged in spring tab, (Fig. 8).
Fig. 8
4. Position springs (A) over posts (B) in
pulley. Install pawls ([C] Fig. 9).
Fig. 9
5. Install retainer (A) making sure that slots
(B) in retainer engage tabs ([C] Fig. 10)
on pulley.
6. Hold retainer down, compressing pawl
springs and install retainer screw. Torque
screw (D) to listed value. See SECTION
14- ENGINE SPECIFICATIONS.
7. While holding retainer, rotate pulley to
extend and retract pawls. If the pawls do
not extend and retract, remove retainer
and reinstall.
Fig. 10
8. Wind up pulley and lock in place.
9. Insert rope and tie overhand knot. See
SECTION 8- Fig. 3.
10. Allow spring to slowly retract rope into
assembly.
8
165