Briggs & Stratton Vanguard 05000 Manual page 105

hinge (C) and both hinge pin posts ([D]
Fig. 46).
19. Install the hinge pin.
20. Turn the carburetor body upside down.
5
NOTE
: The float (A) should be parallel to the
float bowl mounting surface ([B] Fig. 47).
If not parallel:
• Replace the fuel inlet valve, float and
hinge pin.
If still not parallel:
• Replace carburetor.
104
Fig. 46
Fig. 47
21. Install float bowl gasket ([A] Fig. 48) to
carburetor body groove.
22. Make sure the gasket does not twist or
kink.
Fig. 48
23. Position bowl drain ([A] Fig. 49 ) as
shown.
24. Install float bowl (B), washer (C), and
mounting screw (D), to carburetor.
25. Tighten screw ([D] Fig. 49) securely.
Fig. 49
Identifying Main And Pilot Jets
(085400, 115400, 117400, 185400)