Sensor (Booklet End Guide Hp) Lag Jam - Lexmark X95x series Service Manual

Step Action and questions
Check the booklet front tamper
7
motor for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet tamper front
motor (reverse).
5. Touch Booklet tamper front
motor (reverse).
Does the above component
operate properly?
8 Is the booklet front tamper
motor properly connected?
Perform a POR.
9
Does the error continue when
the power is turned off/on?
Perform a POR.
10
Does the error continue when
the power is turned off/on?

381.32 Sensor (booklet end guide HP) lag jam

Step Action and questions
Check the booklet unit interface
1
connector assembly.
Is the above component free of
damage?
Check the main connector on the
2
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Check the main connector on the
3
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Yes
Go to step 6.
Replace the booklet front tamper
motor. Go to
"Booklet front
tamper motor removal" on
page 4-324.
Replace the booklet controller
card assembly. Go to
"Booklet
controller card assembly
removal" on page 4-319.
Replace the finisher controller
PCBA. Go to
"Finisher PCBA
removal" on page 4-350.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
7558-xxx
No
Go to step 5.
Replace the connection.
Problem resolved
Problem resolved
No
Replace the booklet unit interface
contact.
Replace the booklet sensor
interface cable assembly.
Replace the booklet motor
interface cable assembly.
Diagnostic information
Previous
Next
Go Back
2-195